NetBSD 9.3 and current fail in enabling MMC drive for installation

rohshall

I am trying to install NetBSD 9.3 or current on Asus E210M laptop.
And they both fail in enabling the MMC drive, and then it doesn't show up as an installation target.

The errors in dmesg are:

sdhc0 at pci0 dev 28 function 0: vendor 8086 product 31cc (rev. 0x06)
sdhc0: interrupting at ioapic0 pin 39
sdhc0: SDHC 3.0, rev 16, SDMA, 200000 kHz, embedded slot, HS SDR50 DDR50 SDR104 HS200 1.8V, re-tuning mode 1 (128s timer), 2048 byte blocks
sdmmc0 at sdhc0 slot 0
sdmmc0: sdmmc_mem_enable failed with error 60
sdmmc0: autoconfiguration error: couldn't enable card: 60

I see that a few got this issue before as well. Does anyone know the resolution?

rvp

rohshall sdmmc0: sdmmc_mem_enable failed with error 60
sdmmc0: autoconfiguration error: couldn't enable card: 60

error 60 is a timeout error: faulty HW or driver issue. Either way, ask on the mailing-list.

starsnet

rohshall
version 9.3 in my opinion is the most unstable
try version 9.2

rohshall

Thanks. I did ask it on the current-users mailing list, but I didn't get any help. From an earlier thread, it looks like TSC driver is at fault, and not emmc driver. But, I don't know how to switch TSC driver.